Low Rider Urine Sample Collector
Description
This is a low-profile container for collecting a urine sample from a dog. Add a 1/2" (1.27 cm) diameter dowel or PVC pipe as a handle Layer height: 0.2 mm Infill: 12% Print speed: 75 mm/sec Support/Adhesion: none Print time: 4hr 40min UPDATE: I've added the files to build the modular handle. Cut your 1/2" PVC into two sections of desired length. Glue the connector halfway into the end of one PVC section. Feed a length of 1/8" flat elastic through the connector, until it comes out the other end of the PVC. Tie the elastic to an end cap, and place the end cap into the PVC pipe. Slide the clip onto the other section of PVC pipe. Feed the other end of the elastic through this section of PVC, pull it tight, tie it to the other end cap, and place the end cap into the PVC opening.
Statistics
Likes
0
Downloads
0