Barbecue Spatula and Tool Holder for Char-Broil Grill
Description
This hook is designed to go on the inside or outside of the edge of your Char-Broil gas Grill. The hole spacing is 1.5" apart so it may work for any other grill that uses the same hole pattern. It's designed to work with M4x12 or longer screws and an M4 nut. I just printed this with PETG but I'm not sure if it will get too hot in the sun and start to warp. PLA will most definitely start to fail on hot summer days. I will update if the PETG fails in the heat of summer, but It should work perfectly fine with ABS or ASA.
Statistics
Likes
1
Downloads
0