Real Eaton Fuller for Euro Truck 18 speed permanent mod for Logitech shifter
Description
This is a DIY project. The goal is to build a Real Eaton Fuller shifter based in a low-cost Logitech shifter (G25, G27, G29 about 30€ in second hand market), with NO ANNOYING CABLES. Keep in mind, this is for permanent installation and a modification with a Real Pneumatic Eaton Fuller stick, it is not a toy; it´s a real pneumatic shifter knob. Materials list: - 29€ $34 IP-A6918 for Eaton Fuller Replacement (pneumatic)18 Speed Shift Knob Air Valve A 6918 455-5005 https://es.aliexpress.com/item/32947858789.html?spm=a2g0s.9042311.0.0.274263c0IBuvPM - 2m Cable 1M/5M 28AWG UL2464 Sheathed Wire Cable Channel Audio Line 10 Cores Insulated Soft Copper Signal Control Wire https://www.aliexpress.com/item/1M-5M-28AWG-UL2464-Sheathed-Wire-Cable-Channel-Audio-Line-2-3-4-5-6-7/1005001568864782.html?spm=a2g0s.12269583.0.0.735d78aak78Oh5 - x3 Switches KW-1 https://es.aliexpress.com/item/32546855308.html - PETG <30g - 4 Wood Black Screws (M4x10mm) https://www.bricomart.es/ - 1 pair of aerial JST 4 wires conectors https://es.aliexpress.com/item/4000144108861.html?spm=a2g0s.9042311.0.0.274263c0ikDr1p - https://es.aliexpress.com/item/32692164728.html?spm=a2g0o.cart.0.0.15583c00dTkxCC&mp=1 - Optional: DB9 pair connectors (to external arduino case) https://es.aliexpress.com/item/32846096277.html?spm=a2g0s.9042311.0.0.274263c0AllJ7X Electronics parts will be documented later, you can use arduino leonardo or zecodelay devices for wiring the switches. Steps: - Open Eaton Fuller and install (glued) the micro switches with 2 cables normally open when the sticks are down and back. - Optionally you can drill and install one press button (for air brakes or retarder). - All connections will be done with 3 wires and one common wire, to one JST female connector. - Pass the rest of the cable through the shifter, getting hide all of then. - The cable will enter side by side the original cable. If your cable has enough cores you could remove original one (rewiring) or left both side by side. - In order to put the cable inside you must open the shifter and drill a small hole to pass through the lower side to, leader dust protection and al last Eaton Fuller. - Separate the cone-Base of the Eaton Fuller. Drill the holes (2mm) to screw to the adapter. - Print the adapter and put it inside the Eaton Fuller cone base. - Then pass the cable (only four wires) through the leader dust protection of the shifter, the printed adapter inside the cone and then put the male JST 4 wires. - Screw it (cone and adapter) to the shifter stick. - Connect male and female connections. - Test with multi meter, each switches and later reassemble the Eaton Fuller head and screw it to cone. - Build and wire the Arduino adapter; If you are using a G25 oy G27 you can wire the Eaton Fuller installed switches to and any existing buttons. In this way no Arduino or zero delay boards will be needed. - Test it in PC. Carlos Plaza Aguilera
Statistics
Likes
1
Downloads
0