Ender3 / Ender3-Pro / CR-10 / Euclid Probe Mount & Dock
Description
Ender3 mount and Y-carraige plate mounted dock for Euclid Probe. Also applicable to Ender3Pro, Ender3-V2, CR-10, etc... (this does not fit Ender5, see our other repo). Euclid probe is the the most reliable detachable micro-switch probe, unaffected by chamber temps, bed temps, bed materials, magnetism or EM interference. Accuracy and standard of deviations are 1/10 of other probe schemes and sub 0.0012mm. Euclid Probe is THE reliable alternative to BLTouch and its imitations. Original repo on github: https://github.com/nionio6915/Euclid_Probe Most current info, files, firmware and gcode macros at http://www.euclidprobe.com. Config info for Marlin 2.0.x, Duet/RRF and Klipper avaiable there. Kits and assembled probes are available for those who dont want to self-source at http://lukeslab.online. Discussion and support at https://discord.gg/de9kj7zv Probe Offsets for input to your firmware shown in the screenshots. The toolboard mount secures to the X-carriage plate using the M3 screws that secure the hotend fan cover. An altenate version is provided using the M5 roller screw so the mount stays on when servicing the hotend. Due to the different production variations, longer M3 screws may be required (M3x8 minimum length). The probe dock is provided in 2 parts and designed to be hard mounted to the front left corner of the Y-carriage plate. The dock mount is designed to use 1/2″ diam x 1/2″ high nylon spacers to elevate the bed the nominal 15mm above the carrier. These spacers are commonly available at hardware stores and big box stores (links below). Adjust the height of the dock as needed to compensate for the print bed materials. Thin cardboard or fiber washers, silicone orings, or sheet gasket material will help insulate the spacers from the heated bed if higher temp service is required. Adjust the height of the Z-Endstop as well. Links to adjustable endstop holder below. Install one 1/2" spacer under the cable-chain support at the back left location, no riser. Print out 2 of the spacer risers and use them under the front-right and rear-right bed mount screws. You may need to adjust the Z-endstop due to spacer installation (see our other Ender3 mods here on Thingiverse). Home Depot (Everbilt) Spacer https://www.homedepot.com/p/Everbilt-0-194-in-x-1-2-in-x-1-2-in-Nylon-Outer-Diameter-Spacer-2-Piece-814978/204225909 No.10 Screw Fiber Washer https://www.homedepot.com/p/10-x-0-032-in-Black-Fiber-Washers-2-Pieces-807898/204276416 Typical Hardware Store Fastener Drawer Bins Spacer http://typical%20hardware%20store%20fastener%20drawer%20bins/ Attached video shows probe deployment and stow for a single bed-tramming point using Marlin. https://youtu.be/5JAbxNBJOII EDIT 09/28/2021: the mount has been revised to lower the toolhead ~5mm on account of the Ender3 github model not including the gap between the heatblock and heatsink. We apologize for any inconvenience this may have casued.
Statistics
Likes
2
Downloads
0