Kegerator beer tap font labels
Description
I made these labels to fit my Kegerator taps so that I could easily identify what beer I had pouring, whilst still keeping the look neat and elegant as my kegerator is right next to the kitchen! They are super easy to swap in and out too. The brand of Kegerator I have is Kegland but I believe it should slide in just behind most taps (see photo). The gap is just under 3mm so as long as you have that you should be OK. I normally print this at 3x3x3 walls/top/bottom and 10% infill but it doesn't matter too much. Note: This was my first version so the letters will print as is and when you remove them from the print bed they will leave cutouts for letters that have 'islands', e.g. A B D O P. I'm working on a 'Stencil' type font which stops this issue from happening and will upload here when I have time. It's looking good so far. Feel free to use this model for personal non-commercial use, and if you enjoy my work consider buying me a coffee: https://www.paypal.me/brettraymond
Statistics
Likes
1
Downloads
0