ID51 Ram Mount v5
Description
My coworker has an Icom ID-51 radio that he wanted to use with a ram mount. I took the only Icom ID51 mount on Thingiverse and blender'd it up with the RAM mount for GoPro thingi. I have also added the individual STL files for the Ram Mount Ball Hitch, the rear cone, and the holder. **v5: Parted out each component. Measured the clip and determined the clip channel through the cone must be at least 11mm. Not a blender expert so trying my best to hit that depth. I think I'm close, will confirm v4 and v5 with a print out. ** **v4: Make the cone larger in base diameter and depth. Enlarged the channel for the clip and fixed the weird geometry where the clip seats towards the base and weird overhang under the cone. Will confirm fit after another print. ** **v3: Added back the hole that the clip seats into towards the base of the model. This should allow it to be securely clipped in. ~~Waiting on print to confirm it all works.~~ This does not work, the rear channel is to narrow for the clip to fit through.** **v2: I added a channel directly through the rear cone and cleaned up the model further. I will print and test to confirm the radio clip will fit.** **v1: I am not sure that the clip on the radio will clear the cone on the back, this is a v1 and I have not yet printed and tested it.**
Statistics
Likes
1
Downloads
0