Wltoys 104001 Replacement Differential Housing
Description
This is a replacement part for the differential housing on the Wltoys 104001. I have not tried mounting this to the rear of the car but it should fit. The design features a block to prevent installing the differential backwards. This is due to the bevel gears being off center. Use the black cover from the original housing to fully seal the diff in. Use all the same screws from the original. The gear clearances may vary between printers, use shims to get the proper gear mesh. I am not responsible if you strip ring gears! Make sure to use lots of grease, I like Red N Tacky by Lucas Oil. Print laying face down with support material, this orientation will give the most strength to the shock towers. Enjoy :)
Statistics
Likes
4
Downloads
0