Tracer vertical antenna holder
Description
A folding TPU holder for the TBS Tracer antenna so it mounts vertically on a 5mm standoff post, the mount hole is actually 4.8mm to help it grip the post better. Also a version for 6mm posts which is 5.8mm diameter for better grip. It includes two pulltabs so you can unclip it much easier. Best to put the TPU mount on the standoff first, then install the antenna, since the tab could get stuck if you put the mount on the standoff with the antenna already in. NOTE: Be careful when pulling the tabs to unclip the holder to not damage the wire, since this was not designed to be clipped and unclipped repeatedly. Print in TPU, 0.2mm layer height, 3 perimeters, no support. Direct download link from my website: http://www.haku.co.uk/3D/Tracer_Vertical_Antenna_Holder_5mm.stl http://www.haku.co.uk/3D/Tracer_Vertical_Antenna_Holder_6mm.stl You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Statistics
Likes
14
Downloads
0