Dust collection adapter DN100 - 2*DN40
Description
Dust collection adapter from an incoming 100 mm hose to two 40 mm hoses. I use this on my router table to connect both the fence and the router itself to my dustcollector. Works fine with @MariusHornberger 's hose clamps. You have to print 1 x the base piece ("Grundkörper"), 1 x the 100 mm connector ("Stutzen DN100") and 2 x the 40 mm connector ("Stutzen DN40"), then assemble everything with a bit of superglue. The middle screw is a bit hard to get to, if you don't have a long and thin screwdriver. It holds fine with just two screws, though.
Statistics
Likes
0
Downloads
0