LED fixture for Replicator, CTC, Flashforge
Description
I Designed This Bracket To Mount Into The Front Corner Of My Ctc 3D Printer Using 3M Double Sided Tape. It Is Designed To Sit In The Corner And Create A 45* Flat Section To Which A12V Led Strip Was Attached.I Wired The Two Led Strips In Series So That My 24V Power Supply Could Run Them Without Any Sort Of Step-Down Transformer Or A Wall Wort. I Like My Installs To Be Clean. I Wired It Directly To Two Of The Screw Terminals On My Power Supply That Weren'T Being Used And Then Drilled A Hole In The Faceplate Of My Printer To Fit A 3/4" Rocker Switch. Goodbye Days Of Hovering Over My Printer With A Flashlight!
Statistics
Likes
50
Downloads
0