Ender 3 "Bullseye" CR Touch Mount
Description
This is a remix of the original Ender 3 Bullseye BL Touch mount specifically for the CR Touch. Cutout for the cabling was added. All credit for the original goes to https://www.thingiverse.com/thing:2759439 You need to mount the bracket first. You will need 2 x 18mm (ish) m3 bolts 4 x m3 nuts 2 x m3 lock washers Fit the bolts through the CR Touch and lock on with a nut on each. Slot the bolts into the mount, add a lock washer on each, then lock on with a nut on each. The middle nuts are to lower the CR Touch down as it's not as long as the BL Touch See photo for final assembly. Offsets are X-48 Y-10
Statistics
Likes
3
Downloads
0