Geralt - The strong and adaptable phone/tablet mount
Description
This is a fully articulate, adjustable phone/tablet stand that should hold any device up to 7.6" on the diagonal (was designed specifically for the Galaxy Z Fold 3). As of now the only non-3d printed part needed is an 8mm x 22mm x 7mm ball bearing (I used these cause they're cheap https://www.amazon.com/Bearings-Skateboard-Shielded-Miniature-Skateboards/dp/B07R7PR72H/ref=sr_1_8?dchild=1&keywords=22mm+ball+bearing&qid=1633095573&sr=8-8). My original design did not include a ball bearing, you can simply put a cylinder directly attached to the mount and have a bigger hole in the bottom of the gear. I just liked how smooth it was with the bearing and I had them laying around. A few of the printed parts you'll need multiples of: 6x - Nut_M7x1_4 2x - Nut_M14x1.5_8 2x - Side Bracket
Statistics
Likes
1
Downloads
0