Filament Sensor Holder for Neptune 2
Description
Hey everyone, I've got a new part for the Neptune 2, this part should improve the conversion to direct drive extruder (Micro Swiss DD) This holder rotate the entire cable guide and the filament sensor by 90 °, this rotation optimizes the way how the wire harnes an filament goes to the extruder and prevents the cables from pinching or getting stuck Please note! these Setup is intended to be used with the original Neptune 2 Filament sensor, there are two models, the "Filament_Holder_FOR_BRASS_Fitting" model is intended for a thread insert at the Bowden end. The other model has a smaller hole (9.5mm) so that you can screw the tube fitting directly into it, but I haven't tried this yet you allso need to drill a hole in the aluminium Z-carrier plate of the printer (3,5/4mm) Hardware: 3 screws and 2 cable ties i used: 2x M3x25mm 1x M3x10mm Have Fun :-)
Statistics
Likes
2
Downloads
0