Battery Holder/Pedestal AA/AAA/9Volt
Description
PLEASE READ: *When printing use Combing mode in Cura (under travel setting) and set to ALL, this will eliminate all stringing whatsoever in the slots of the part *You Can print at 0.2mm or even 0.25mm layer height would work fine *15% infill is sufficient or even 10% will work fine There are only 8 tiny supports needed at the small overhangs *its a long print because its about 8.5 inches in total height, took me almost 24 hours to print on my Creality Cr10 V2 printer *If you want a shortened version please email I wouldn't have a problem shortening it for you in CAD so it prints faster *This is very sturdy, it has thick walls, reducing the wall thickness doesn't reduce much of printing time *The battery Pedestal Will hold: 9 9Volt Batteries 32 AA Batteries 25 AAA Batteries Overall dimensions are: 5.5x3.875x8.875 inches Thanks
Statistics
Likes
4
Downloads
0