Breakout board support bracket
Description
This is a bracket to support breakout boards attached to hp server power supplies. These are directional but this one is supposed to work with breakout boards going in the same direction as the one this is remixed from. That board holes are offset as the breakout boards are not centered. I never screw directly into plastic but there are 3 mm holes as a guide to put a brass insert. I used a 2 @ m3 x 6mm brass insert using a soldering iron to push them in. Of course will need 2 m3 screws about 8mm long to attached the board to the print.
Statistics
Likes
2
Downloads
0