Duet Panel Due 7i Pendant for RatRig VCore3
Description
I wanted a screen mount that could double as a pendant. This is meant to swivel out of the way when not in use and can also rotate for the best viewing angle. It will also open up mounting options. I personally use it most as a pendant when working inside the printer. You can take the screen out of the mount when needed. I found this to be most helpful when tuning the printer and when doing maintenance. There is also a hole and spacing for a 16mm switch. I use this to control LED lighting in the printer. Hardware Needed: __________________________________________________________ *8x M3x8mm Flat Head Thread-forming Screws For mounting the screen bezel to the case and the Pane Due to the bezel. https://www.mcmaster.com/95893A189/ __________________________________________________________ *1x M5x20mm Flanged Socket-head Screw *1x 9.5x7.5mm O.D. Spring *1x M5 Nyloc Nut These are for assembling the swivel arm mount. Tighten the M5 screw until there is enough tension to hold the assembly together, but loose enough that it can be pulled out and rotated. https://www.mcmaster.com/90074A104/ https://www.mcmaster.com/8969T689/d ___________________________________________________________ *4x M4x8mm Flat Head Screws *4x M4 Nyloc Nuts For attaching the pivot arm to the Case https://www.mcmaster.com/91294A188/
Statistics
Likes
5
Downloads
0