120VAC Outlet Holder
Description
I've spent over a HALF ROLL of filament to get this to work! This is my famous snapfit recessed style outlet holder! I did put a little super glue along the edge of the inner as pictured to strengthen the bond! I would say you shouldn't have too. But if you do at least wait dry time like hours to a full day. I almost gave up on this and to say that it was designed to be put in sheet metal. It was VERY HARD to get a structural bond to hold this in place especially testing pulling the plug out and not pulling out the socket with wires! Maybe my most difficult design I had over had todo in my life! because the amount of waste produced and printing soo many fails that were soooo close. Then all of a sudden YANK! This NEW DESIGN PREVENTS ALL THAT! Used in Raspberry Pi IoT https://www.thingiverse.com/thing:4992092
Statistics
Likes
0
Downloads
0