Hobby Knife Anti-Roll Safety Cap
Description
A quick Remix of Misoguchi's EXCELLENT make! I never can keep up with safety caps. I often use an inclined desk, so I needed a bit more "Anti-Roll" built into my Safety Caps to keep my X-Acto knives off the floor... and to keep those Number-11 Razor Blades from sticking out of my legs and feet ;) I also have several Older X-Acto Knives that measure out at about 9.87mm (The Tightening Screw for them is at the back of the Handle), so the second, shorter, cap marked "10mm" fits those. As you can tell, I printed these at 0.3 Rez, 100% Infill, and "Ludicrous-Speed mm/s" in Cura to get them done in under 30 minutes each. Please toss me a Motivational Like if you find this useful ;) Cudos to Misoguchi!!!!
Statistics
Likes
54
Downloads
0