1/4 inch air hose fittings
Description
These are created because I needed them in plastic and all I could find locally was brass. I printed them on 0,15 res 100% infill and concentric fill. If you use PLA and a glass bed, there is no need for a raft. To make the thread go in you just have to trim the elephant's foot a little if any. I also printed one out in Nylon... asI want to use them in my HHO machine and PLA does not like water. I used Weed eater chord 240 deg hot-end and bed 80 with a glue stick on the glass bed to help adhesion a little. Hope you find them useful. If so, please support me by subscribing on my YT channel The QuixotryWorkshop. :-)
Statistics
Likes
1
Downloads
0