Aprin Neck Pain Relief Device
Description
I made this to give myself some relief from some minor neck pain caused by an apron I have to wear at work. The pain is a minor distraction. Seeing as I work with some dangerous equipment, this could be bad. The device uses two hooks, and a piece of string (about 3 feet / 1 meter long). In the picture shows the device attached to the apron strings in back. To build, get some craft string. (Or any sturdy string. I bought a small ball of craft string from a craft store.) Cut to length. (about 3 feet / 1 meter long) I tied off the ends to keep them from unravelling. Print the two hooks. Tread the string through the two holes in the hooks. Next knot the string ends togather. Make the sure the distance between the hooks is about 8" to 12" apart. (about 18 to 25 cm). (adjust this length to fit the person's back.) When the device is hooked on, it should be comfortable. All it does is pull the apron neck string down a little from the person's neck.
Statistics
Likes
0
Downloads
0