Carrier for Roborock Vacuum Roboter (S7)
Description
Lift up and carry your Roborock S7 was quite weird. You needed always two hands for going down the basement stairs or going up to the bedrooms in upper floor. My Roborock S7 is about 4.5kg of weight, putting another 450g to it and carry it in one hand is so much easier. So I designed and bilt this carrier. When you lift the handle the three forks clamp your robot and hold it safely. Opening is to release (and push slightly) the handle down. Then a little exercise and the handle leaveds the robot for the next mission. You need to be quite confident in your 3D-printer, to lift a couple hundred bucks and let it freely hang on earlier 1.75mm filament. Try it before with a much higher weight to see if it will do the job.
Statistics
Likes
13
Downloads
0