LF1 Nerf Outer Barrel Rubberband Conversion (+Boost to inner spring!)
Description
Just can't find the spring? China got you by the balls and you're paying $10 a pack of 2mm gauge spring that are 70-80cm in length? Just use rubber...bands! Loop it around your inner loop and pull it away to the tip ;) Beware, your piston head will be in extreme peril, best print in PETG or ABS.....PLA will just shatter if you use less than 2 1cm thick rubber bands. 0.5mm Nozzle 100% Infill (Concentric for top and bottom and infill is recommended for full strength) PLA! it is strong enough for 4 Rubberbands but bewarned, do not place eyes unprotected while using the iron sight*) Future improves will be notches for the rubber bands to sit on, maybe design it more for the extreme end, this has good general reinforcements in terms of sheer and plastic deformity. Temperature will be at the discretion of the end user. If you find that your hole is too tight, use some sandpaper (ok not in real life, the innuendos stop just here). 80grit, rill it real tight, cut out the general amount, then use it as your barrel enlarger. If this is not done, it will give inconsistent fire. Coconut oil is a good lubricant, i recommend using it and the design works much smoother.
Statistics
Likes
1
Downloads
0