Pipokeball
Description
Finally a single file print pokeball! it opens, it closes. It's 1 file. Print with supports, domes up. a little post print work. "Wear down" the pin and the pin hole with a file or knife. take the pin down by half, and round it smoove. Then "break in" the pin hole by filing or carving out a "ditch". Round out the circle tab if it printed warped. And if neccessary, use filler on rims where met by supports, and sand smoove. I personally just print, and break in, they are durable and make a satisfying "SNAP!" when closed. Enjoy! Video here! My only youtube contribution thus far hah! https://www.youtube.com/watch?v=t6qtpZRRanA
Statistics
Likes
4
Downloads
0