V6 40mm Fan Shroud + 5015 Radial Fan
Description
Designed this for my Ender 3's V6 hot end since I couldn't find one that I could use. This duct was made with the simple metal holder for Ender 3 V6 mount in mind. Practically the same as a stock V6 fan duct, but uses a 40mm fan with a 5015 radial fan holder by the side. Uses M3 screws for the fans. It's only attached by the V6 radiator so it rotates in place if its tugged on.
Statistics
Likes
1
Downloads
0