Berd AIr EVA duct

Berd AIr EVA duct

Description

I have made a Berd Air duct for the EVA print head. I tested it only with the Dragon hotend so far. There are little notches in the duct as a guide for the holes in the pipe. I closed the pipes by soldering them. You can use the drilling jig to cut the pipes to the correct length of 32mm. Just put the 3mm pipe into the hole, drill it with a 1,5mm drill and then cut it. I use the a 6/4mm tube to connect the Berd Air with the duct

Statistics

Likes

5

Downloads

0