Mag base for Worker angled Talon mag
Description
Tactical mag base for Worker angled short dart mag, there are two version, with and without screw holes, the one without screw hole can be fixed with double side tape on the bottom, my printer usually 0.2mm smaller Inside dimension so it is tight fit without any tape. When I cut the long mag into a shorter length, then I use the one with screw holes. The screw hole are 2mm, drill to desired diameter for M3 or 4-40 set screw. The shorter side are designed to the same side of mag release notch.
Statistics
Likes
5
Downloads
0