Strömer Charger CR245/CR190 Holder / Wall Mount
Description
A sleek designed wall mount for the Strömer CR245 charger. Not tested with the CR190 but should work (let me know). * Fits like a glove; * minimizes the amount of plastic; * looks beautiful; * comes with a *cable clip*. ### Charger mount Can be printed without support in PLA and CPE. Probably other plastics work just fine. Print with the opening down. The model wil be slightly slanted, that's OK. * Use fine layer height: 0.1-0.15mm * Infill: 40% (to strengthen the screw holes) * Build plate adhesion: brim *Optional* * Tune the z-seam alignment to be at the back. * Use another (break-away) material for the build plate adhesion layer. ### Cable clip Print in two parts; enable bridging if available; no build plate adhesion if possible (to avoid cleanup). You'll need to insert an iron/magnetic washer (outer diameter < 1.9mm / inner diameter > 5.6 mm / thickness < 1.9mm) and glue the pieces together. You can use acetone/acrylic glue/super glue depending on the material used.
Statistics
Likes
3
Downloads
0