Oculus Quest 2 Elite - Velcro Battery Holder
Description
A generic battery/powerbank holder for the Oculus Quest Elite band (with the flush adjusting knob - this will not work with the one that sticks out) This is held solidly in place by Velcro and movement is restricted by the extrusions around the adjuster. Print upright (so the Oculus logo is the right way up, but the flat side is on the bed), 10% infill is fine, pictured is 0.28 layer height. As shown in the picture: - Anker Power Bank, PowerCore Slim 10000 - Velcro One Wrap 20mm - SUNGUY USB C Cable Right Angle (From Amazon) Inspired by this below model, however designed from scratch in TinkerCAD (In case you do your own, the curvature of the band is a 180mm diameter circle, at least by my measurements): https://www.thingiverse.com/thing:4630781 Clip is a "remix" of this (Although I have only added the n3rd wording to match): https://www.thingiverse.com/thing:4668735 Leave a comment and I may make some additional versions!
Statistics
Likes
0
Downloads
0