Baofeng/BTECH ham radio edge stand with BL-5 battery eliminator
Description
I liked CodeBender's stand, but wanted it to have a cutout for the BL-5 battery eliminator cable, as my hams are powered directly from dc, no batteries. This holder is meant to hangs off the edge of a table, so the cable has somewhere to go - the hanging off part is printed as the bottom. The part that actually rests on the table is printed on supports, but it's wide and flat and works well. It attaches to the table surface with basic 1" two-sided tape I had lying around. I printed mine in PolyMax PC black, and lowered the support gap to 1 layer height. Used .35 layers for quicker printing as vertical quality doesn't much matter here. p.s. I have the BTECH-UV5X3 model but it should fit most Baofeng models.
Statistics
Likes
5
Downloads
0