Use leftover filament to make this Variable Height Stackable Storage

Description

THERES A ISSUE WITH THE DOWNLOAD ALL BUTTON BUT... the individual download button works fine Have an unknown amount of leftover filament left? you are afraid to use it on your main prints as it might run out? you can use this simple stackable print design where it is okay to run out, what you get is just a smaller height container! I made this design when I was looking around for ways to use the leftover prints and someone suggested printing a vase and when the filament runs out it can be a bowl, This improves on that design by using ALL your variable "bowls" and making a huge stack of containers for small items. The edges are rounded, but the internal "hole" is square so you can fit square things in it The design of this variable container is that it has a small notch at the bottom to stack with the top of other containers. There is also a separate print for the cap so that the topmost container can be open or closed. The dimensions at 100% can fit 4 calibration cubes (40mmx40mm) and the height is around 50mm you can also print it at 200% so you can place larger items and make them into pencil cases (then print a small one for your paper clips on the bottom) or vases for plants. It is perfect for storing nozzles, or screws, USBs/SD Cards, rings, tiny Lego elements or other smaller items ** at the time of writing I am just about to run out of filament so I have not tested it fully will update when I run out ** different filaments also mean different colors and will just make your containers look better.

Statistics

Category

Tags