Piranha 12 LED light mounting system (HW-5V-12LED)
Description
Piranha 12 LED light mounting system (HW-5V-12LED) with a shade, tilt and swivel mount. No supports needed (well, maybe except the nut pockets on the shade - they come out okay, depends on how good your printer can bridge). Requires: - M3 hardware: 2 or 4 M3x8 screws (for the LED PCB), 2 M3x10 screws for the shade side mounts, 1 M3x14 screw for the swivel, nuts - 2 M4 wood screws for attaching the top bracket. Insert nut into middle hole of the top bracket (use the same screw pull method to get it in), then mount it with two screws to a flat surface. Insert 2 nuts into the side pockets of the horizontal bracket in the same way, then insert an M3x14 screw in the middle hole. Attach to top bracket. Insert 2 nuts into the side pockets of the shade. Mount LED PCB into the shade using 2 or 4 M3x8 screws. Insert 2 M3x10 screws into the side holes of the horizontal bracket. Attach shade to horizontal bracket. Adjust as needed, tighten screws.
Statistics
Likes
29
Downloads
0