HiPrecy LEO 2 x 4010 Fan Bracket
Description
Fan Bracket for cooling the Stepperdrivers at the F6 or S6 controllers installed in the HiPrecy LEO 3D printers. The bracket is designed for 2 4010 fans and is mounted over 2 of the additional mounting studs inside the housing for the electronics. Note: there are several additional mounting studs inside the electronics housing in a 115 x 92mm array. Exactly the size for fitting a Duet controller. Makes life a bit easier for someone who would like to experiment with a Duet controller in a HiPrecy LEO. The bracket is mounted in the housing by 2 8mm M3 screws and washers. For mounting the fans you will need 4 M3 brass inserts, length 3mm, diameter 4mm. Melt them inside the bracket. Fans are then attached to the bracket with 4 M3 12mm screws (in case of 4010 fans). Finally, put a sticker from your favorite filament brand over the 2 holes left by the original bracket for the 30mm fan :-)
Statistics
Likes
1
Downloads
0