Apostel for Nerf Darts
Description
This is an Apostel for carrying powder charges. But in this case you can store a nerf Dart in them. I made this one for my LARP Costume, to go with the Wheellock Pistol from carnyrex. Youtube Link: https://www.youtube.com/watch?v=Ex31WIJA3x4&ab_channel=SnightloT Print Advice: You can print the Lid/Cap without any supports, the Base need supports on the upper part. I had the best Results with paint on supports in Prusa. If you use Cura or another Slicer, select Support angle at 89, otherwise you will get Supports on the Rings, but with a good cooling they should be fine, at least with 0.6 layer width. The Supports in the middle of the Base can be tricky to remove, I drove a flathead Screwdriver in, this worked good for me. Your Printer should be dialed in, so that the Cap will fit snugly on, otherwise you may have to sand it. When you dont want to paint them up, you can try to print them with woodfill Filament.
Statistics
Likes
4
Downloads
0