Voron Afterburner Adafruit ADXL345 Mount
Description
This is an Adafruit ADXL345 mount for the Voron Afterburner toolhead. It uses the two lower hotend fan housing M3 bolt locations to attach the mount and gets the sensor close to the nozzle. To install the chip to the mount use two M2x10 or M2x12 bolts and two M2 nuts. I also used two M2 washers stacked in between the chip and mount to offset the chip to account for my imperfect soldering of the header pins. You can then remove the two M3x12 bolts from the bottom of the toolhead, slide the mount assembly on and attach it using two M3x20 bolts. I recommend doing this after ensuring your toolhead is in position to perform input shaper resonance measuring and will not need any homing or bed leveling operations performed as the sensor will likely crash into the bed. Note: The Adafruit ADXL345 chip differs in dimensions than that of other commonly used chips from Ali or Amazon. The mounting hole pattern is of primary concern as it is 19mm on this chip and 15mm? on others. Please confirm your chip shares these dimensions to ensure compatibility. I may upload another version to address this later.
Statistics
Likes
4
Downloads
0