Filament Guide for Elegoo Neptune 2S
Description
This is a simple filament guide i made because the filament scratched against the hole of the extruder. This resulted in an anoying squeaking while retracting and extruding. I was highly influenced by ssegarra's "Guía Filamento Elegoo Neptune 2" (thing:4852043). But i don't want to buy new screws. So i made a flat version with bevels for the screws. Now you can use the existing ones. I added a testpart you can use to check the fitting of the holes. This was printed in 7 minutes. The hole print took about 40 minutes. ----------- I just added Version 2. With a flatter mountingplate and a offset for the guidiance.
Statistics
Likes
10
Downloads
0