10mm LED-strip holder for 2020 profile
Description
Hello, I didn't quite like the fit of the original since it was quite loose for me. And also a bit too thin. So I decided to open Solidworks and design my own, which I printed and already used on my own printer ;). It looks awesome with some single addressable WS2812B RGB LED's. The led strip is 10mm in width. I included the .SLDPRT and .obj file for you to adjust if you need to. Simply edit the width in the first sketch that got extruded. Leave a like if you like my design or the tight fit ;-) Printer: Ender 3 V2 Fit: Tight ;-) Note: I printed this vertically which worked best for me. No rafts or brims needed I only used skirt with 3 lines. Infill doesn't really matter but 20% was fine. Do however spray the bed with some adhesion spray just to make sure it doesn't come lose halfway through a print.
Statistics
Likes
8
Downloads
0