SAF 8" FPV frame
Description
Props out of view @ around 25 degree gopro tilt - CF parts 1 - 8topplate in 3mm (0.5mm chamfer outside/battery strap slot on both sides) 1 - 8bottomplate in 3mm 1 - armplate in 3mm 4 - 8incharm in 8mm (or 8incharmhorned for more motor protection) - Hardware 10 - m3x20mm standoff 16 - m3x8mm 20 - m3x12mm (16 for motors, 4 for gopro mount) 4 - m4x16mm 4 - m3x30mm for FC/ESC 1 - m3x16mm for center bolt where legs meet 4 - m4 pressnuts 5 - m3 pressnuts - 3d prints 2 - airunitcameramount (one mirrored) 1 - capholdernew (fits a 50v 1000uf i have, sure makes esc soldering easy) 1 - reardualantennamount 2 - airunitholdernew (one mirrored) 2 - immortal t 1 - GoPro 10 mount, i designed 20/30degree versions with lens protected versions of each, mounting is 32mmwidex40mm long Recommended motors - 2809 1250kv or 3110 1250kv for freestyle, 3106 1200kv for longrange Recommended batteries - GNB 3300mah 6s or 4200mah 6s Designed to use 20cm camera cable for air unit in rear, although there is room in front for airunit to be taped in if out of 20cm camera cables Shout out to Straw Hat Sam for the center bolt arm locking idea, start the 2 outer bolts on all your arms first(leave em loose) and leave the center bolt last... it will be tight but should start threading into carbon/pressnut(i use socket head for first install to get the extra torque of a 2.5mm head) Im careful when it starts to hit pressnut to makesure it threads in good, might take some backing out and in for a bit to feel a clean start. Sometimes arms might need to be filed at the center bolt if its too tight, i disassembled one proto and used a small round file
Statistics
Likes
1
Downloads
0