iPhone Magsafe Adjustable Weighted Stand
Description
STEGO BOARD Product Name: iPhone Magsafe Adjustable Weighted Stand This adjustable stand was designed to be functional, while also appearing unique with a bit of industrial and mechanical design. Angle adjustments towards your face can be made based on your height, combined with the stand's location, providing you with personal customization. The fully reclined position is for someone who wants less distraction as well as privacy regarding screen notifications being displayed. It is designed to fit the iPhone Pro with a bumper style case, providing centered alignment with the magsafe charger, while avoiding collision with the larger rear camera bump. There are curved cutouts to help deflect sound towards the front of the stand. There is also a cable cutout should you require data transfer while wireless charging. The ball bearings have three functions. To look cool, add weight to the stand and snap to magnets inside the leg while in the fully reclined position. Four of the twelve balls will lift up and snap onto the leg when fully reclined. The cable is run through the back center cable guide when in this position. Ball bearings, magnets and rubber feet are not required for the use of this stand although it is encouraged for the best overall user experience. The phone shown in photos is an iPhone 13 Pro with a Spigen Rugged Armor case. Assembly instructions: Place the ball bearings into the main body base. Apply Crazy Glue to the top outside ridges of the main body base. Place the main body base cover with ball cutouts on and press down. Tape in place. Add rubber feet to the bottom of the main body base. Install screws and nuts to top and bottom of magsafe charger body at all corners. Apply Loctite to screws and place nuts into bottom magsafe charger body hinge spots. Drive screws in until secure. Do not over tighten. Apply Loctite to screws and place nuts into top magsafe charger body hinge spots. Align leg hinge holes. Place nuts into top of leg. Drive screws in until secure. Do not over tighten. Leave Loctite to properly set before using. Apply a very small amount of silicone adhesive or similar to the back of the magsafe charger. Center and align the cable downward. Tape in place. Guide cable through leg opening. Leave glue to properly set before using. Leg magnet installation instructions: Apply silicone adhesive or similar into the magnet cavities. Insert magnets and press down. Apply more silicone adhesive to the top of the magnets. Add magnet covers and press down. Leave glue to properly set before using. Requires: Eight M3 x 8mm long machine screws. Eight M3 nuts. Loctite. Crazy Glue. Tape. Optional: Four magnet discs 1/2" diameter x 1/8" thick (12.7mm diameter x 3.18mm thick). Magnets can be found on Amazon by searching magnet 12 x 3mm round. Twelve ball bearings 1/2" diameter. Ball bearings can be found on Amazon by searching 1/2" ball bearing. Four Foor Rubber Feet Everbilt 1/2" Self-Adhesive Clear Surface Bumpers can be found at Home Depot. Silicone adhesive or similar. For ideas on how to use this 3D printed item, visit: [stegoboard.com](https://stegoboard.com)
Statistics
Likes
6
Downloads
0