Claymore Hitch Cover (Remix)
Description
I wanted a version that attached the back tube more securely to the face. I read a review of a model someone was selling on Amazon that said there's came apart on the first drive to work. I added screw holes to the tube to secure it better than simple glue. There is a 1mm raised post on the back to help align the tube in the center. Also added a flange around the end of the tube that keeps in pretty well locked in place in your receiver with no slop. Can be a snug fit at first, but it will go on. I use short #6 or #8 screws (whichever i have on and at the moment) to fasten the two pieces together. Also scaled the face down slightly to, I believe, 90%. 194.9mm x 112mm x 28.8mm I print both with a .8mm nozzle on either my Ender 3 or Ender 3 Pro. My settings - Layer Height - .2 Initial Layer - .2 Wall thickness - 1.6 Top/Bottom thickness - 1.0 Enable Ironing - Off Infill density - 20% Infill pattern - Cubic Subdivision Nozzle temp - 210 Bed temp - 60 Flow - 100% Print speed - 50 Enable retraction - On Retraction distance - 6.5 Retraction speed - 25mm/s Retraction min travel - 1.5 Combing mode - All Fan speed - 100% Supports - No Build plate adhesion - None Enable coasting - On Filament - Overture Black PLA GL Robotics Desert Tan PLA Paramount 3D Military Green PLA
Statistics
Likes
0
Downloads
0