Hex Organizer
Description
I designed this from scratch but the idea was based off the Cable Management Hive. I had two goals. 1. Increase the size of the Hex(Roughly 50 mm from wall to wall) 2. Create it in such a way that it could be printed in Spiralize Outer Contour.(cura). "Vase Mode" It took a few versions before I could get the lines close enough that they could bond together. This is designed for a .4 nozzle. It's a fairly large print at 200x188x90 but should fit most machines. I would advise against scaling it up on either the x or y because it will increase the gaps between the hexs and it won't keeps it's rigidity.
Statistics
Likes
1
Downloads
0