Two Trees Sappheiros S Hotend Mount and slider V7
Description
Made a new version for all Sappheiros S or Sapphire S holders. This version got a replacement of the metal part on the slider. The main advantages are easy maintenance, weight and access. You don't need to disasseble all for maintenance. Belt tensioning is more reliable even as the positioning of the belts so they don't push them over the pulleys anymore. In the PDF I made a detail description and the hardware needed to to assemble all. Holes and inserts can be critical specialy with very small 3mm inserts. Some do fall directly threw the hole due to other measurements or more or less shrinkage of the plastic. You can compensate for this in Cura. It is called Hole horizontal expansion. This feature has the exact same effect as horizontal expansion, except that is it only applied to closed holes on the X,Y plane of every layer, and not on the outside part of the model. This may help overcome screw holes that shrink too much and need to be compensated for. Note: Where horizontal expansion adds material with a positive value, this feature removes material with a positive value. Example: A value of 1 will make the hole bigger by 1mm in every direction! It's higly appreciated if you like and use the model you give a donation of an euro. This cover my cost and motivation high. Regards, Frank
Statistics
Likes
11
Downloads
0