Lego ISS (21321) wall mount
Description
I loved my Lego ISS, by I hated it had to stay in dark corner due to lack of space. So I designed and printed 1 piece wall mount for it to show off. I am also attaching .rsdoc file (DesignSpark Mechanicle) so you can adjust it freely. Length is 265mm so it will be a bit challenging for you to fit it on the print bed. There is about 50mm space left between model and the wall. I didnt want to have the model so close to the wall, so I used the whole capacity of Ender 3 printable space. Also please note that the space where you put your ISS base is a bit bigger. It is on purpose, because if you have small mistakes during printing, you have small space for errors to be made, therefore you dont have to throw away whole print and start over again. And as the bed is moving while it is printing, tall models can have small fragments end the very end of print.
Statistics
Likes
5
Downloads
0