Makergadgets Innovator Wire Plug
Description
This is a wire management hole and PTFE passthru for the Makergadgets Innovator enclosure. The plug fits the roughly a 1 3/8" in the back left of the enclosure, sealing it off but letting wires through. Two pneumatic connectors screw in each side with a PTFE coupler between them. This lets you keep dryboxes with heat-intolerant materials stay outside of the enclosure, along with your electronics. This needs to be printed in TPU for the flexible flaps to work. TPU is also heat-tolerant enough for inside of the enclosure. Assembly requires 2 M3 x 16mm screws and 2 M3 nuts.
Statistics
Likes
1
Downloads
0