Lee Load All funnel lid
Description
Funnel lid for Lee Load All shotshell reloader. Used to quickly and selectively empty shot and powder (depending on orientation). DISCLAIMER: I am not responsible for your reloading results, proceed at your own risk! I printed it using ABS for better impact resistance / thermal stability / elasticity but PETG and even PLA may be OK. Enclosed is SCAD source so you can adjust the model to your particular printer tolerances. HIGHLY RECOMMENDED to use some kind of clasp latches to fix lid in place (see picture). However it is quite snug as printed, so there is no danger that the lid comes off while emptying. However, there is a risk that when the lid isn't fully seated, powder may leak into shot compartment and vice versa.
Statistics
Likes
4
Downloads
0