Christmas Light Brick Clip
Description
Merry Christmas!! I was hanging Christmas lights today and needed a way to hang them on brick. I tried other ways but didn't have much luck, so I jumped on Fusion 360 and made my own hanger. Printed with PETG for extra strength. Print with zero infill, 2 layers on the vertical shell, and 3 layers on the top and bottom. Each one is a fairly quick print on a Prusa (approximately 11 min at .3 layer height) 2 sizes (62.5mm and 65mm) to best meet your needs. If you have any suggestions to make it better feel free to comment. Thank you!
Statistics
Likes
34
Downloads
0