Toyota Spare Switch Hole Cover (with and without hole for switch)
Description
Designed for newer model Toyota Tacoma. May work on other Toyotas. Front plate is 23 mm by 33 mm. It was created to house the switches for an aftermarket seat warmer toggle switch, but I have included a blank one for customization or replacing an existing cover. There are 2 models with the switch hole. The one with the registration tab is very fragile as it is close to the edge. I was able to get the switch into the hole without the registration tab cut out as it just bends the side a bit. Both worked well once installed in the truck. I recommend printing on the side if using FDM to increase strength of the tabs on the back and using supports. There is a slight draft angle, so it may sit on the printbed at a tilt. Printed in Hatchbox black PETG.
Statistics
Likes
1
Downloads
0