Thrustmaster T3PA/T3PA Pro Pedal raiser
Description
I found the original design was too steep (at least for the pro pedals on my setup YMMV), so I angled them back a bit. I also found that the lower screw was too long making it impossible to put in the hole for mounting the riser without damaging the hole on the riser. This problem was made worse with it angled back, so I enlarged the original hole to allow for the screw head to pass through, as well as added a second hole for the upper mounting screw, as angling it back causes the same issue for that one as well.
Statistics
Likes
4
Downloads
0