X9D gimbal guard for five33 Rip Sticks
Description
REMIX WARNING! This part is designed for an X9D radio. The Tx16s pictured will NOT work for this print. You can find the print designed for the Tx16s on my profile. Designed for TPU print with support for overhang angle set to 60deg. there should just be 3 little support spots under each gimbal guard. the rest of the guard should be able to print without support on a good working machine. for my print the fit tester ended up being slightly tighter than the actual gimbal guard. on my machine the 14.3mmID design will stay on until you smack the back of the radio, then it slides off. The default is designed for pretty tall sticks. if you want it to be lower profile you can reduce the vertical scale in your slicer. this may make the overhangs harder to print.
Statistics
Likes
1
Downloads
0