Ubiquiti Unifi AP AC Pro Stand
Description
Simple horizontal (preferred orientation for the stronger signal coverage) stand for a Ubiquiti UniFi AP AC Pro. Bonus: reminiscent of a pizza saver (pizza table). No screws or glue required. I designed this to lift my access point off of the switch that sits below it, and allow more air to flow. As I looked at other designs they either had a large amount of wasted filament required for supports, or required a vertical orientation. This takes ~7 grams of filament and just 45 minutes to print. Vertical orientation is nice to save space, but actually affects the signal strength as these access points produce a donut shape (see the image [here](https://community.ui.com/questions/Antenna-Up-or-Down/aa4f003e-a182-4950-a798-05e734d6cd12)). Given I couldn't mount it to my ceiling (rental apartment), I chose this as the next best option.
Statistics
Likes
11
Downloads
0