Mini T/B Fan Waterfall
Description
WARNING - This is untested as of 12-1-21 at the track but it is in my car and working. Be warned that I believe that if the fan is not running you may overheat your motor - Make sure you check your motor temps. This waterfall is for a 20mm fan, I used a HW one that fits right in. I did make all the screw holes a little smaller than needed so just make sure that you test fit all your hardware before final install, pre-drilling all the holes is probably a better idea. This mount can be used for the B bodies or I have included the T tower that will bolt right up through the other hole on the top if you so choose to run the truck body. I STRONGLY suggest that you use TPU for the T body mount. I also did a test fit with higher tooth gears and I was able to fit a 60/22t pinion spur combo, anything past this may need minor modifications. Also, this tower will probably make the chassis more solid so be aware. If you are here and don't have a printer you can ask Paul at http://eaglesviewaerial.com/?page_id=283 to print and sell/ship one to you, he is the only person that I have given permission to sell/ship my item. Print with the fan mount down and add a support for the two fan screw stops.
Statistics
Likes
7
Downloads
0